Best PKEX2245 Installation Manual download pdf (Page 9)

12. CONNECT WIRING (ALL MODELS)

WARNING

Risk of electric shock. Electrical wiring must be done by qualified personnel in accordance with all applicable

codes and standards. Before connecting wires, switch power off at service panel and lock service disconnecting

means to prevent power from being switched on accidentally.

Position the power pack below its custom hood.

HE0157

INTERNAL BLOWERS: Insert the house wiring cable through the wire clamp

previously installed in step 8. Tighten the wire clamp to

secure the cable. Connect cable into electrical compartment

using included wire connectors. Connect BLACK to BLACK,

WHITE to WHITE and GREEN or bare wire under green

ground screw. DO NOT FORGET TO CONNECT THE

GROUND. Reinstall electrical compartment cover.

IN-LINE OR EXTERNAL BLOWERS: See instructions included with blower.

13. CONNECT DUCTING (ALL MODELS)

A. When there is access to the top of the hood, connect ductwork and seal connections with metal foil duct tape after Step 14 Install power

pack.

B. When there is no access to the top of the hood, carefully pull down the metal duct through the custom hood base hole. Slide this duct

over the adapter (internal blower) or over the flange of the rough-in plate (in-line or external blower). Make sure the adapter/damper

assembly enters the ducting. Seal joint with metal foil duct tape.

14. INSTALL POWER PACK

CAUTION

Take care not to kink ducting when installing the power pack.

TIP: Two of the six no. 8-18 x 1¼” provided chrome plated screws can be

used to temporarely support the power pack during installation. Place

the power pack inside the custom hood and insert both side screws.

The power pack can now be secured to the custom hood without having

to hold it in place.

HD0497

SUPPORT SCREW LOCATIONS

HD0498

MOUNTING SCREW LOCATIONS

Using provided no. 8-18 x 1¼” chrome plated screws, secure the power pack

inside the custom hood. Install 1 screw at each corner. (See figure at right for

mounting screw locations.)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 47 48

No comments

Best PKEX2245 Installation Manual Page 9