Best U10230SBI Installation Guide download pdf (Page 11)

- 11 -

INSTALL FILTERS

(NON-DUCTED HOODS ONLY)

1. Install a charcoal filter on each side of the

blower (included with Nonducted

Recirculation Kit Model ANKU10).

2. To install the charcoal filter, align two keyhole

slots on the filter with locking tabs on the

blower. Rotate to lock filter into place.

3. To remove the charcoal filter, rotate the filter

until it disengages from the blower.

NON-DUCTED

RECIRCULATION FILTERS

INSTALL ELECTRICAL

WARNING: All electrical wiring should

be done by a qualified person (s) in

accordance with all applicable codes and

standards. This range hood must be

properly grounded.

1. Run 120 VAC electrical power cable to the

hood’s wiring box.

2. From inside the hood, remove the wiring box

cover.

3. Secure the conduit to the wiring box through

a conduit connector.

4. Make electrical connections at the hood.

Connect white-to-white, black-to-black and

green to ground.

5. Replace the wiring box cover and screws.

Make sure the wires are not pinched

between the cover and box.

6. Connect power at the service entrance and

check hood for operation.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

No comments

Best U10230SBI Installation Guide Page 11