Best IM32I100SP Installation Manual download pdf (Page 13)

- 13 -

INSTALL WIRING

1. Drop the ceiling canopy. Feed the

wires through the center of the ceil-

ing canopy. Wire tie the two power

cables to the support arms. Insert the

wires onto the strain relief and into

the junction box. Secure the wires by

tightening the strain relief. Make the

power connections Fig. 16.

2. Feed the wire safety cables through

the center of the ceiling canopy and

along the support arms and insert

into the cable supports as shown in

Fig. 1 7. Repeat for each power unit.

A. Push cable through support rods

and into hood cavity.

B. Slide washer and cable clamp

with barrel nut onto cable. Note

that the barrel nut must be slightly

backed off of cable clamp and

pushed (spring compressed)

when sliding assembly onto cable.

C. Push clamp assembly all the way

to the top of the hood while push-

ing down on barrel nut. Fig. 1 7.

D. When assembly is all the way to

the top inside of hood, completely

tighten barrel nut. Fig. 18.

E. Cut excess cable off.

Fig. 16

JUNCTION

BOX

POWER

CABLES

STRAIN

RELIEF

WIRE

WAY

GROMMET

Fig. 17

HEX NUT

NOTE: CABLE CLAMP ASSEMBLY

INCLUDES BARREL NUT AND HEX NUT.

BARREL NUT

Fig. 18

CABLE CLAMP

ASSEMBLY

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 59 60

Comments to this Manuals

No comments