Best WTT32I36SB Installation Manual download pdf (Page 6)

- 6 -

CLEANING & MAINTENANCE

For performance, appearance, and health reasons, clean filter, fan and grease-laden

surfaces regularly. Use only a clean cloth and mild detergent solution on stainless and

painted surfaces.

Clean all-metal filters in the dishwasher using a non-phosphate detergent. Discoloration of

the filter may occur if using phosphate detergents, or as a result of local water conditions -

but this will not affect filter performance. This discoloration is not covered by the warranty.

Clean the non-duct recirculating filter surfaces frequently with a damp cloth and a mild

detergent. DO NOT immerse filters in water or put in dishwasher. Change the non-

duct recirculating filters every 6 months. For replacement non-duct recirculating filters

- purchase S97018968 or Model AFCWTT32 (for 30” wide hood) or S97019039 or Model

AFCWTT326 (for 36” and 42” wide hoods).

The motor is permanently lubricated and never needs oiling. If the motor bearings

make excessive or unusual noise, replace the blower assembly with an exact service

replacement.

LIGHT BULBS

WARNING:

Bulbs may be hot.

Always allow bulbs

to cool down before

removing them.

Use (2) Halogen Bulbs

(included with hood) -

120 V, 50 W, shielded

halogen bulbs - MR16

with GU10 base. (3

bulbs for 42” & 48”

hoods.)

NOTE:

Suction Cup Tool

(included with hood) can be used to install and remove light bulbs. Align pins on bulb

with large diameter opening on socket, then push bulb in towards hood and rotate

clockwise until firmly seated. The position of the bulb socket (depth) is adjustable and

may require adjustment when: a) certain brands of bulbs are difficult to install. b) the

bulb protrudes too far below the light panel.

LAMP SOCKET

BRACKET

SCREWS

LIGHT

PANEL

To change the depth of bulb

sockets:

- Remove screws on light

panel – set screws aside

- Remove Light Panel.

- Loosen 2 Screws holding

Lamp Socket Bracket to Light

Panel.

- Adjust socket/bracket to

desired depth.

- Re-tighten screws securely.

- Re-attach light panel with

screws that were previously

set aside.

(1)

PUSH IN

(2)

ROTATE

CLOCKWISE

SUCTION

CUP TOOL

HALOGEN

BULB

1 2 3 4 5 6 7 8 9 10 11 ... 67 68

Comments to this Manuals

No comments

Best WTT32I36SB Installation Manual Page 6

Comments to this Manuals

Related products and manuals for Cooker hoods Best WTT32I36SB