Best iQ6 Installation Guide download pdf

MODEL iQ6

Page 1

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR IN-

JURY TO PERSON(S) OBSERVE THE FOLLOWING:

1. Use this unit only in the manner intended by the manufacturer.

If you have questions, contact the manufacturer at the address

or telephone number listed in the warranty.

2. Before servicing or cleaning unit, switch power off at service

panel and lock service disconnecting means to prevent power

from being switched on accidentally. When the service discon-

necting means cannot be locked, securely fasten a prominent

warning device, such as a tag, to the service panel.

3. Installation work and electrical wiring must be done by qualified

personnel in accordance with all applicable codes and stan-

dards, including fire-rated construction codes and standards.

4. Sufficient air is needed for proper combustion and exhausting

of gases through the flue (chimney) of fuel burning equipment

to prevent backdrafting.Follow the heating equipment

manufacturer’s guidelines and safety standards such as

those published by the National Fire Protection Association

(NFPA), and the American Society for Heating, Refrigeration

and Air Conditioning Engineers (ASHRAE), and the local code

authorities.

5. When cutting or drilling into wall or ceiling, do not damage

electrical wiring and other hidden utilities.

6. Ducted fans must always be vented to the outdoors.

7. Do not use this range hood with any additional solid-state

speed control device.

8. To reduce the risk of fire, use only steel ductwork.

9. This unit must be grounded.

TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:

a) Never leave surface units unattended at high settings. Boilovers

cause smoking and greasy spillovers that may ignite. Heat oils

slowly on low or medium settings.

b) Always turn hood ON when cooking at high heat or when

cooking flaming foods.

c) Clean ventilating fans frequently. Grease should not be allowed

to accumulate on fan or filter.

d) Use proper pan size. Always use cookware appropriate for the

size of the surface element.

WARNING

TO REDUCE THE RISK OF INJURY TO PERSON(S) IN THE

EVENT OF A RANGE TOP GREASE FIRE,OBSERVE THE

FOLLOWING*:

1. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or

metal tray, then turn off the burner. BE CAREFUL TO PREVENT

BURNS. IF THE FLAMES DO NOT GO OUT IMMEDIATELY,

EVACUATE AND CALL THE FIRE DEPARTMENT.

2. NEVER PICK UP A FLAMING PAN – You may be burned.

3. DO NOT USE WATER, including wet dishcloths or towels – This

could cause a violent steam explosion.

4. Use an extinguisher ONLY if:

A. You know you have a Class ABC extinguisher and you know

how to operate it.

B. The fire is small and contained in the area where it started.

C. The fire department has been called.

D. You can fight the fire with your back to an exit.

* Based on “Kitchen Fire Safety Tips” published by NFPA.

CAUTION

1. For general ventilating use only. Do not use to exhaust

hazardous or explosive materials and vapors.

2. To avoid motor bearing damage and noisy and/or unbalanced

impellers, keep drywall spray, construction dust, etc. off power

unit.

3. This blower has a thermal overload which will automatically

shut off the motor if it becomes overheated.The motor will

restart when it cools down.If the motor continues to shut off

and restart, have the hood serviced.

4. Please read specification label on product for further

information and requirements.

5. To reduce the risk of fire and to properly exhaust air on a ducted

installation, be sure to duct air outside – Do not exhaust air

into spaces within walls or ceiling or into attics, crawl spaces,

or garage.

INTERNAL

BLOWER

INSTALLER:

Save this manual for Electrical Inspector

and Homeowner to use.

For use with compatible BEST

range hoods.

See hood manual for suitability.

1 2 3 4 5 6 ... 15 16

Summary of Contents

Page 1 - INTERNAL

MODEL iQ6Page 1WARNINGTO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR IN-JURY TO PERSON(S) OBSERVE THE FOLLOWING:1. Use this unit only in the manner

Page 2 - RANGE HOOD SYSTEM

MODÈLE iQ6Page 101243586771611119101415121317PIÈCES DE RECHANGEModèle iQ6+ NON ILLUSTRÉ# ILLUSTRÉ DÉMONTÉ* MATÉRIEL STANDARD. EN VENTE DANS UNE QUINC

Page 3 - INSTALLATION

MODELO iQ6Página 11ADVERTENCIAPARA REDUCIR EL RIESGO DE INCENDIO, DESCARGA ELÉCTRICA O LESIONES PERSONALES, OBSERVE LOSIGUIENTE:1. Use la unidad sol

Page 4 - CALIBRATE iQ BLOWER

MODELO iQ6Página 12SISTEMA DE CAMPANA DE ESTUFA CON VENTILADOR INTERNOTapas de pared y techo, ventiladores exterioresCodosSistema de tuberíaSistema

Page 5 - SERVICE PARTS

MODELO iQ6Página 13INSTALACIÓN1. Haga pasar el cable eléctrico al sitio de la instalación.2. Retire un agujero ciego eléctrico de la caja de cablead

Page 6 - VENTILATEUR

MODELO iQ6Página 144. Quite la cubierta de la conexión eléctrica.5. Conecte el cable eléctrico a la caja del cableado con el conector adecuado. Cone

Page 7 - ÀVENTILATEUR INTERNE

MODELO iQ6Página 151243586771611119101415121317PIEZAS DE SERVICIOModelo iQ6+ NO SE MUESTRA# NO SE MUESTRA ARMADO* TORNILLERÍA ESTÁNDAR. SE PUEDE COMP

Page 8

MODELS / MODÈLES / MODELOS iQ6Page / Página 16GARANTÍA LIMITADA DE UN AÑO PARA LOS PRODUCTOS BESTBroan-NuTone LLC (Broan-NuTone) garantiza al consum

Page 9 - VENTILATEUR iQ

MODEL iQ6Page 2INTERNAL BLOWERRANGE HOOD SYSTEMWall & Roof Caps, Exterior BlowersElbowsDuctworkBlowerSystemWP28M, WP29M,UP26M, UP27MSERIES HOODS

Page 10 - PIÈCES DE RECHANGE

MODEL iQ6Page 3INSTALLATION1. Run power cable to installation location.2. Remove one electrical knockout from rough in plate wiring box. VERTICAL

Page 11 - VENTILADOR

MODEL iQ6Page 44. Remove wiring cover. 5. Connect power cable to wiring box using proper connector. Connect Black to Black (hot), White to White (n

Page 12 - CON VENTILADOR INTERNO

MODEL iQ6Page 51243586771611119101415121317SERVICE PARTSModel iQ6KEY PART DESCRIPTION QTYNO. NUMBER1 97019389 ROUGH IN PLATE WELDMENT 12 98003370 OUT

Page 13 - INSTALACIÓN

MODÈLE iQ6Page 6AVERTISSEMENTAFIN DE DIMINUER LES RISQUES D’INCENDIE, D’ÉLECTROCUTION OU DE BLESSURES, SUIVEZ CES DIRECTIVES :1. N’utilisez cet appar

Page 14 - VENTILADOR iQ

MODÈLE iQ6Page 7SYSTÈME DE HOTTE ÀVENTILATEUR INTERNECapuchon mural et de toit, ventilateurs extérieursCoudesConduitSystème de ventilateurCONDUIT DÉC

Page 15 - PIEZAS DE SERVICIO

MODÈLE iQ6Page 8INSTALLATION1. Acheminez un câble à trois fils jusqu’au lieu d’installation.2. Enlevez la rondelle détachable de la plaque de raccor

Page 16 - 99045165B

MODÈLE iQ6Page 94. Retirez le couvercle du boîtier de câblage.5. Fixez le câble d’alimentation au boîtier de câblage à l’aide du connecteur appropri

Best iQ6 Installation Guide

Browse online or download Installation Guide for Unknown Best iQ6. Best iQ6 iQ6 Installation Guide 99045165B.pdf User Manual

Summary of Contents

More documents for Unknown Best iQ6

Comments to this Manuals

Best iQ6 Installation Guide

Browse online or download Installation Guide for Unknown Best iQ6. Best iQ6 iQ6 Installation Guide 99045165B.pdf User Manual

Summary of Contents

More documents for Unknown Best iQ6

Comments to this Manuals

Related products and manuals for Unknown Best iQ6