Best K210A Installation Guide download pdf (Page 11)

- 11 -

12. LIGHT BULBS

13. INSTALL FILTERS

14. USE AND CARE

Grease filters and impeller(s).

The grease filters, impeller(s) and grease rail should be cleaned frequently. Use a warm detergent solution.

Grease filters and impeller are dishwasher safe.

Remove filters by pushing filters towards the back of hood and rotating filters downward.

Remove filters by pushing filters towards the back of hood and rotating filters downward. Clean all-metal filters in the

dishwasher using a non-phosphate detergent. Discoloration of the filter may occur if using phosphate detergent or as

a result of local water conditions—but this will not affect filter performance. This discoloration is not covered by

the warranty.

This range hood must use shielded halogen lamps (120 V, 50 W, MR16 or PAR16 with GU10 base), included.

1. Install the lamps by placing the bulb leads into their grooves in the socket.

2. Gently push upwards and turn clockwise until secure.

To remove lamps, gently push upwards and turn counterclockwise to disengage bulb leads from their grooves.

NOTE: If need be, use a rubber dishwashing glove to add grip when removing the bulb.

WARNING

In order to prevent the risk of personal injury, do not install a

lamp identified for use only in enclosed fixtures.

WARNING

In order to prevent the risk of personal injury, the halogen

lamps must be cooled down before removing them.

HO0090

It is recommended to install side filters first and finish with center one(s).

1. Insert upper end of filter into the hood (tab end).

2. Raise lower end toward the inside of hood.

3. Position lower end of filter into channel and pull.

4. While pulling the filter, slide it under the inner retaining piece.

Baffle filters are available as an option (see instruction sheet included with baffle filters).

HD0009

HD0056

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

No comments

Best K210A Installation Guide Page 11