Best U10230SBI User Manual download pdf (Page 10)

- 10 -

INSTALL THE DUCTWORK

(DUCTED HOODS ONLY)

NOTE: To reduce the risk of fire, use only

metal ductwork.

1. Decide where the ductwork will run between

the hood and the outside.

2. A straight, short duct run will allow the hood

to perform most efficiently.

3. Long duct runs, elbows, and transitions will

reduce the performance of the hood. Use as

few of them as possible. Larger ducting may

be required for best performance with longer

duct runs.

4. Install a roof or wall cap. Connect round metal

ductwork to cap and work back towards hood

location. Use duct tape to seal the joints

between ductwork sections.

INSTALL THE DUCTWORK

(NON-DUCTED HOODS ONLY)

NOTE: The following material must be

purchased separately for non-ducted

recirculation installations.

• Non-ducted Recirculation Kit Model ANKU10

(contains 8" to 6" reducer and two charcoal

filters).

• 6" round metal ductwork and fittings.

1. Remove and discard the aluminum damper

flaps from the 8" duct connector.

2. Attach the 8" to 6" reducer to the 8" duct

connector.

3. Attach 6" round metal ductwork and fittings.

4. Run ductwork to the location where it is

discharged back into the room.

5. Duct tape all joints to make them secure and

air tight.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Comments to this Manuals

No comments