Best WTT32I36SB Installation Guide download pdf (Page 12)

- 12 -

Flush with

the ceiling

Center of

installation

Upper flue mounting

bracket slots

Ceiling

INSTALL THE HOOD

(Ducted Hoods Only)

1. Center the flue mounting bracket over the hood location and flush with the

ceiling. Secure the upper flue bracket to the wall using (2) 4mm x 38mm

mounting screws. Note: Drywall anchors may be required (not included).

2. Tighten the screws completely. Make sure that the bracket is tight against the

wall and ceiling.

3. Remove the protective plastic film covering the decorative flue and the hood at

this time.

4. Remove the grease filters by pulling down the metal latch tab and tilting filters

downward to remove.

5. Remove all internal foam fillers that support the blower assembly inside the

hood.

6. For 48” wide hood only: Attach damper / diverter to top of hood using (2) 4mm

x 8mm mounting screws.

7. Attach the damper / duct connector (8” diameter for 30”, 36”, and 42” wide hoods

and 10” diameter for 48” wide hood) using (4) 4mm x 8mm mounting screws.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 67 68

No comments

Best WTT32I36SB Installation Guide Page 12